Multi-Sensor-Module SENSOdive - MODBUS

The multi-sensor module SENSOdive - MODBUS is equipped with a MODBUS RTU interface and is therefore ideally suited for connection to higher-level data acquisition systems (data loggers, PLC, etc.). The wide range power supply combined with a low current consumption allows a simple electrical connection. The calibration data for the individual sensors are stored within the probe.

To request more information and prices call +49351/88646-00 or e-mail us: info@uit-gmbh.de.

  Sensors - 3 Sensors plus pressure and temperature
  Relative pressure sensor   0 ... 10 m; 0 ... 20 m; 0 ... 50 m; 0 ... 100 m water level
  Absolute pressure sensor   800 - 2,100 mbar; 800 - 6,100 mbar; 800 -11,100 mbar
  Temperature sensor   0°C ... 50°C; resolution: 0.04 °C
  Conductivity sensor   0 ... 20 mS/cm; resolution 1 μS/cm or 0- 0,2/2/20/500mS/cm; resolution up to 0,1 µS/cm
  pH   1 ... 14; resolution ΔpH = 0.01
  Redox potential   –2,000 ... +2,000 mV; resolution 1 mV
  pH/redox – combination sensor   pH 1 ... 14; redox –2,000 ... +2,000 mV
  DO [O2] – luminescence   0°C ... 40 mg/l O2; resolution 0.02 mg/l O2
  Ion selective sensors   Chloride, nitrate, ammonia and bromide – specification on request
  Technical data – SENSOdive – Probe
  Dimensions   Measurement probe: diameter: 48 mm; length: 600 mm
  Material with medium contact   Stainless steel; POM; PUR, EPDM, NBR, PE plus sensor materials
  Probe cable   Cable sheath PUR or PE
  Output signal   MODBUS-RTU- RS485
  Power supply   6 ... 14 VDC; 100 - 300 mA depending on equipping status, warm up time 10 s, switchable
  Operating temperature range   0 °C ... 50 °C

Illustrations and descriptions may vary. The plant / product is subject to change depending on technical updates.

We will gladly give you an individual offer.

Anfrageformular



Back to overview

Latest modification: 23.09.2022